Instruction Manual

Introduction to the Halo G6 e-Cigarette

Welcome to the world of electronic cigarettes. Your purchase of the Halo G6 e-cigarette allows you, as a committed smoker, to continue getting the taste and sensation you crave without inhaling smoke and tar. No more cleaning the ashes collected around your home or worrying about whether your clothes and hair smell like smoke. Since Halo’s G6 cartomizers give you full control over your nicotine intake, you can even work toward the goal of eventually consuming no nicotine while still enjoying the experience of “vaping”. This instruction manual will help you get started with the Halo G6 and ensure that you get the most out of your electronic cigarette experience.

Getting Started

After removing your Halo G6 batteries and charger from the package, confirm that the batteries are fully charged. Connect a battery to the USB charger by turning it clockwise until it is fully seated, and then connect the USB charger to the port on the end of the wall plug. Connect the assembled charger to a wall outlet. The LED inside the USB charger glows red when it is connected to a power source, and the LED on the end of the battery glows when the battery is charging. When the LED tip turns off, the battery is fully charged. Halo recommends charging a new battery for eight hours before using it for the first time.

Tip: When charging a Halo G6 battery for the first time, use a wall outlet. In the future, you can charge the battery from a computer USB port.

Assembling the Halo G6

The Halo G6 e-cigarette has just two parts: the battery and an all-in-one atomizer and flavor cartridge called a “cartomizer.” To assemble the G6, screw the cartomizer clockwise into the threading on the end of the battery until it is seated securely. The G6 is now ready to use.

Using the Halo G6

The Halo G6 is available with automatic or manual batteries. If you have never used an electronic cigarette before, you can also purchase the G6 with one of each battery type to see what you prefer. The automatic battery has an air hole in the middle of the threading, allowing it to detect when you inhale turning on automatically. Simply use it as you would a real cigarette. The manual battery allows for total control; push the button to turn the battery on and release it when you are done inhaling.

Tip: As a cigarette smoker, you are probably accustomed to taking short, fast puffs. To get the most vapor out of your Halo G6, take long, slow puffs.

The Halo G6 e-Cigarette Battery

The automatic and manual batteries have glowing LED tips that blink to notify you of their status. The G6 e-cigarette battery has a built-in timer that shuts the battery off when it is engaged for more than five seconds. This allows the battery to use its charge economically and keeps your e-cigarette working longer before you need to recharge it. When the five-second timer shuts the battery off, the LED flashes twice. When the battery is dead, the LED flashes for several seconds. The standard 78mm battery lasts for about 300 puffs between charges, while the 65mm mini battery lasts for about 200 puffs. Charging a dead G6 e-cigarette battery from a wall outlet or USB port requires approximately two hours, and the battery can handle approximately 300 charge-discharge cycles before the maximum capacity begins to decrease.

The Halo G6 e-Cigarette Cartomizer

The polyfill interior of the G6 cartomizer holds 1ml of e-liquid and is available in nicotine strengths of 6, 12, 18 or 24mg per ml. When you select the correct nicotine level for your needs, one five-pack of pre-filled cartomizers should last for about one week. Because each cartomizer is a sealed unit that also contains the atomizer needed to heat the e-liquid and turn it to vapor, you do not need to worry about declining vapor production and can expect your G6 e-cigarette to perform like new every time you use it. When the flavor quality or vapor production of a cartomizer begins to decline, it is out of e-liquid. Simply remove the cartomizer and begin using a new one.

It is also possible to refill the G6 cartomizer when it runs out of e-liquid, allowing you to save additional money by purchasing e-liquid by the bottle and buying new cartomizers only as needed when your existing cartomizers need to be replaced. The lifespan of a cartomizer can vary. G6 cartomizers can be refilled approximately five times before you will begin to notice declining vapor production.

To refill a cartomizer, remove the soft plastic stopper from the tip. Inside the cartomizer, you will notice two items: the center air hole and the polyfill material surrounding it. When you use the G6 e-cigarette, vapor travels to your mouth through the center air hole. To avoid leaking or gurgling sounds when using the Halo G6, e-liquid should not be allowed to enter the hole. Tip the e-liquid bottle or dropper against the edge of the cartomizer and release a few drops at a time directly above the filler material. Allow several seconds for the liquid to saturate the material before adding more. After approximately 20-30 drops, you should notice that the liquid pools slightly on the filler material without soaking in. The cartomizer is full. Replace the stopper and enjoy.

Tip: If you are unable to open the G6 cartomizer with your fingernail, you can use a toothpick or tweezers.

Try a new e-liquid flavor with your Halo G6 today.

Tribeca CartomizersMenthol ICE E-LiquidMidnight Apple E-LiquidPrime 15 Cartomizers
Halo G6 Tribeca CartomizersHalo G6 Menthol Ice E-LiquidHalo G6 Midnight Apple E-LiquidHalo G6 Prime 15 Cartomizers
Halo's take on the classic "RY4" flavor; tobacco with a sweet caramel top note. A must-have for lovers of sweet tobacco.A powerful menthol blast with an undertone of the finest tobacco. The Halo e-liquid to try if you are a menthol lover.Mix Halo's incredible tobacco base with a hint of zesty green apple, and you get an e-liquid you won't be able to put down.Simply one of the most realistic tobacco e-liquid flavors available; subtle sweetness with notes of dark chocolate.
$9.99$5.99$5.99$9.99